Manufacturer's Part#: CFETF1011105
Product Dimensions: 5 Inches x 2.25 Inches x 7.5 Inches
Weight: 0.5 Lbs

Features:
General Information
- Product Line: CFETF10xx-105
- Marketing Information: Transition Networks' full-featured 100BASE-TX to 100BASE-FX Media Converters, cost-effective integration of twisted pair and fiber optics in Fast Ethernet networks is easier than ever before.

Networking
- Ports: 1 x RJ-45 (female) 100Base-TX, 1 x ST (female) 100Base-FX

Media & Performance
- Connectivity Media: 100Base-TX Category 3, 5 (UTP/STP), 100Base-FX 1300 nm Multimode (Fiber)
- Data Transfer Rate: 100Mbps Fast Ethernet
- Supported Distance: 328.08 ft maximum Category 3, 5 UTP/STP, 1.24 mi maximum Multimode Fiber

Protocols & Management
- Protocols Supported: Fast Ethernet
- Status LEDs: Unit LED:

• PWR

• TX (Link Copper)


• FX (Link Fiber)

• Use SNMP at an attached terminal or at a remote location to monitor the Media
  Converter by monitoring:




• Media Converter power


• Copper link and fiber link status


• Hardware switch settings


• Fault Condition

• Use SNMP to enter network commands that:




• Enable/disable


• Full- / Half-Duplex


• Enable/disable


• Link Pass-Through (LPT)


• Power down the Media Converter

• Only Transition Networks guarantees compatibility with any 10/100 compliant port. This feature allows you to force the proper port configuration through an external switch on the converter; unlike competitive products that ship in auto-negotiation mode and may require both hardware and software configuration.


• Automatically detects and reports loss of link on a connection using Link Pass Through. This feature allows the equipment at the remote end of a link failure to "see" this failure and respond with corrective actions, such as Spanning Tree fail-over links, proprietary trunking links, or failure reports through SNMP or RMON procedures built into the switch, router or hub.


• Deploy fiber in a strategic and economical manner by using Fast Ethernet converter. Fast Ethernet converter can extend distances that copper cannot reach. This Converter can be used in
  conjunction with lower cost copper based equipment to extend fiber to remote users.
  

• Min TX PWR: -19.0 dBm


• Max TX PWR: -14.0 dBm


• RX Sensitivity: -30.0 dBm


• Max In PWR: -14.0 dBm


• Link Budget: 11.0 dB

• Point System chassis

• IEEE 802.3
  
• CE Mark
  
• FCC Class A
  
• CISPR Class A
  
• VCCI Class 1
  
• FCC & CISPR Class A devices comply with radiated emissions standards for commercial applications in the United States (FCC Class A)
  
• FCC & CISPR Class B devices comply with radiated emissions standards for residential applications in the United States (FCC Class B)